How to change from FIT to FAT mode in Sundray XAP-610-S
1. Connect the network cable directly from your PC to the device
Default IP of the device is 192.168.100.1
2. Configure the IP of your PC with similar IP range with the device
3. Download the troubleshooting tool here.
4. Extract the tool and run the troubleshooter
8. Change with the following values below
9. Enter the password to connect to device, the default is "admin"
10. Click refresh button to reflect the changes (wait for a while beause this might take a while)
11. Go to your terminal and try to "ping" the default IP of the device
3. Download the troubleshooting tool here.
4. Extract the tool and run the troubleshooter
5. Click the network adapter where your Sundray device is connected and wait until the scanning was finish.
6. The window below will appear ince the scanning was finished
7. Select the device and select Tool->Change Mode
8. Change with the following values below
9. Enter the password to connect to device, the default is "admin"
12. Go to your browser and browse the IP of the device, below screen should appear.
Default password is "admin"
Congratulations! you sucessfully change the mode of your sundray device from FIT to FAT.